This connector is mostly used on CCTV / Security Installations.

Product Specification:

Connector:2.1*5.5 DC connector

• Length: 30cm

• Female connector

This connector is mostly used on CCTV / Security Installations.

Product Specification:

Connector : 2.1*5.5mm DC connector

Length: 30cm

This CCTV BNC extender can be used with any DVR or CCTV set up to extend the BNC connection. This extenders works 1:1. It comes as a set transmitter and receiver.

Sample Installation Diagram:

This Power Extension DC Cable will split 1 x Female DC Connector to 4x Male DC Connectors.

Features:

Manage your power more efficiently with this brand new 1 to 4 power splitter
Simply plug the female jack into an AC to DC power adapter to power multiple electronic devices

• Use this power splitter cable instead of other extra cords
• Cable Length: 39cm/15inches
• 4 DC outputs in standard 2.5mm of the most common size
• Perfect for CCTV security camera application in home or office
• Inner Size: 2.1mm
• Outer Size: 5.5mm

This product is commonly used with power supplies below:

5 Volt, 2A AC/DC Power Adapter – Power Supply for USB or any 5v Device

9 Volt, 2A AC/DC Power Adapter (Switched Mode Power Supply)

12 Volt, 2A AC/DC PSU | Power Supply for Router, External Hard Drive Enclosures or CCTV Cameras

Instructional Video on CCTV Power Cable Splitters and Setup

Passive PoE is a simple way of providing power to an access point which is not located near a power adapter and which supports Power over Ethernet. Passive PoE uses free wires in the Ethernet / Network cable and sends the equipment power along them to the far end. Over a short distance, it is usually possible to use the power adapter supplied as standard with the access point. If the loss of the voltage on the wiring along longer lengths of Ethernet cable is too high, it is possible to use a more powerful power adapter, to eliminate the loss of voltage.

The DC Power Input to the POE Injector is Distributed to the RJ45 Network Pins below:

POE Injector Application and Example Configuration and Usage Video

Cable Usage and Installation Example:

Passive PoE is a simple way of providing power to an access point which is not located near a power adapter and which supports Power over Ethernet. Passive PoE uses free wires in the Ethernet / Network cable and sends the equipment power along them to the far end. Over a short distance, it is usually possible to use the power adapter supplied as standard with the access point. If the loss of the voltage on the wiring along longer lengths of Ethernet cable is too high, it is possible to use a more powerful power adapter, to eliminate the loss of voltage.

The DC Power Input to the POE Injector is Distributed to the RJ45 Network Pins below:

POE Injector Application and Example Configuration and Usage Video

Cable Usage and Installation Example:

Use this connector to convert standard F-Type Male connectors listed at Male F-Type Connector to a BNC Male connector. This solution provides a cheaper alternative than buying expensive long distance BNC cables, have less signal loss than low quality BNC cable and the RG / Coax cable can be cut to length required.

PLEASE NOTE! Do not use these adapters to connect an RF antenna signal into a Composite video BNC port or visa versa. When using this for composite signals, you should have an BNC adapter on both ends or BNC on one end and Composite / Yellow RCA on the other end.

Note!! Be very careful when inserting the coax or it will bend the internal conductor and render the connector unusable.